BASETech 814677 Mode D'emploi page 19

• Do not work with the device in areas where there is danger of explosion, flam-
mable liquids, gasses or dusts.
• Keep children and other persons away from the device during operation. It is pos-
sible that you loose control of the device due to distractions.
• Pay attention to what you do and make sure that you go about your work in a
sensible fashion.
• Do not use the device if you are tired or under the influence of drugs, alcohol or
medications. One moment of carelessness when using the device can result in
severe injuries.
• Avoid accidental switching on of the device. Ensure that the power tool is switched
off before inserting the connector into the socket. If your finger is on the switch
of the device or the device is connected to the power supply, this can result in
accidents.
• Remove adjustment tools or wrenches before switching on the device. A tool or
wrench that is inserted in a rotating part of the device can result in injuries.
• Ensure safe stance while working. Always keep your balance.
• Do not wear any loose clothing or jewelry. Keep hair, clothing or gloves away from
rotating parts. Loose clothing, jewelry or long hair can get caught in moving parts.
• Do not overload the device.
• Disconnect the device from the power supply before making any adjustments to
the device or changing the tools. This prevents inadvertent starting of the device.
• Keep the device out of the reach of children. Do not allow persons to use the
device who are not familiar with it or who have not read these instructions.
• Keep the power cord away from rotating insert tools. If you loose control of the
power tool, the power cable can be severed or caught.
• Handle the device with care. To ensure the device is working properly, check
whether moving device parts are working perfectly and do not stick, whether parts
are broken or damaged. Have damaged parts repaired before using the device.
Many accidents are the result of poorly maintained power tools.
• When using third-party accessories, observe the operating advisories of the
particular manufacturer. Note the maximum speed when using third-party acces-
sories or tools.
• Ensure that all accessories and collet chucks of the device match.
• Use only tools and accessories that are intended for such use or are identical in
design for this device.
19