erba 25071 Mode D'emploi page 11

GB - INSTRUCTION MANUAL
8. OPERATION INSTRUCTIONS
Installation:
Don't mount the worklight to a wall that is prone to vibrations or instability.
Deactivate the power circuit (1)
Remove the mounting bracket from the worklight (2)
Use the mounting bracket as a stencil to mark the holes for drilling.
Drill the required holes and hammer concrete dowels (M6x20) in. (3)
Screw the mounting bracket to the wall (4)(5)
Remove the cover of the cablebox and install the powerchord as shown in images 6 and 8.
Brown = L, Blue = N, Green/Yellow = Ground/GND
Secure the cable inside the cablebox (9)
Close the cover of the cablebox (10)
Now you can reactivate the power circuit (11)
See image 12 for propper alignment and safety clearance.
Motion sensor (Models 25076, 25077 and 25078):
You can adjust the motion sensor using the three dials on it's backsiede as follows:
SENS:
Adjust the sensors sensitivity here. The higher the sensitivity, the easier the sensor will be
triggered by motion and activate the worklight. To avoid accidential activation (eg. by
birds, cats, etc.) use a lower sensitivity setting.
TIME:
Adjust how long the worklight will be active. You can adujust the duration between approx.
7 and 600 seconds.
LUX:
Adjust the ambient light sensitivity of the sensor. Turning the dial towards the moon-
symbol will cause the sensor to be active only in low light conditions or at night. Turning
the dial towards the sun symbol will cause the sensor to be active all day long.
ERBA GmbH
A-1230 Wien
Talpagasse 6
Servicehotline: Tel: +43(0) 1 930 10 - 160 · Fax: +43(0) 1 930 10 - 960 · E-Mail: service@erba.at
Page 11
25071, 25072, 25073, 25076, 25077, 25078, 25081, 25082, 25083
Changes, print, punctuation and other errors reserved!
Instruction manual
Issue: 05/2017