Safety Regulations; Items Supplied - HERKULES SHZ 500-2 Mode D'emploi D'origine

Anleitung_SHZ_500_2_SPK7:_
GB
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.

1. Safety regulations

CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
1. Always check that the mains voltage is identical
to the voltage quoted on the rating plate. In the
event that the mains voltage is not suitable, it
may cause the machine to work abnormally and
thus result in personal injury.
2. The power supply must be earthed and be
secured by a residual current operated circuit
breaker (RCCB).
3. Do not attempt to lift loads that exceed the rated
load.
4. Use the equipment only for the purpose for which
it is designed. Never transport personnel using
the cable hoist.
5. Do not pull the power cable in order to pull out
the plug. Protect the power cable from heat, oil
and sharp edges.
6. Never attempt to transport fixed or jammed
loads.
7. Pull out the plug when the cable hoist is not in
use.
8. Keep children and other unauthorized persons
away from the machine.
9. Do not pull loads sideways or from one side. Do
not allow the load to swing.
10. Ensure that the hook moves in the same
direction as shown on the control switch.
11. Check the cable hoist at regular intervals for
signs of damage. The control switch must be in
good condition.
10
06.04.2010 8:32 Uhr Seite 10
12. Have repair and servicing work carried out only
by authorized workshops by a trained electrician.
Repair work must only be carried out by a trained
electrician, otherwise the machine may cause
accidents.
13. Do not switch the machine on and off quickly
(inching mode).
14. Always concentrate fully when operating the
cable hoist.
15. Do not stand or work under the raised load.
16. Wear a protective helmet.
2. Layout (Fig. 1-2)
1. Fastening bar
2. Fastening hole for hook
3. Drum
4. Lever for maximum cable length
5. Automatic stop mechanism lever
6. Steel cable
7. Cut-out weight
8. Hook
9. Emergency Stop switch
10. Pushbutton
11. Remote control
12. Power cable
13. Control cable
14. Motor
15. Return roller
16. Additional hook

3. Items supplied

Open the packaging and take out the equipment
with care.
Remove the packaging material and any
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
Inspect the equipment and accessories for
transport damage.
If possible, please keep the packaging until the
end of the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys. Do not let children play with plastic bags,
foils or small parts. There is a danger of
swallowing or suffocating!