Intended Use; Location Of Controls; Unpack Device; Assembly / Disassembly - Proficook PC-HM 1026 Mode D'emploi

Intended Use

This appliance is intended for mixing, stirring,
beating, pureeing or cutting food. It is suitable for
processing common household quantities.
It is only designed for this use and should only be
used for this intended purpose.
Only use this device as instructed in this user
manual. Do not use this device commercially.
No other use is intended and can cause damage
or personal injuries.
The manufacturer is not responsible for any dam-
ages incurred due to improper use.

Location of Controls

1 Multi-function switch and button
• On/Off switch
• Switch for speed settings 1 to 5
• Eject button for dough hooks and beaters
2 TURBO button
3 Fixture with cover for attaching the blender
stick
4 Ring marking
5 Dough hooks
6 Blender stick
7 Housing
8 Fixture for attaching dough hooks and beaters
9 Beaters

Unpack Device

1. Take the device out of its packaging.
2. Remove all packaging materials, such as foils,
filling materials, cable ties and cartons.
3. Check that all accessories are included in the
box.
4. If the contents of the box are incomplete or if
damage is found, do not operate the appliance.
Return it to the dealer immediately.
NOTE:
Clean manufacturing residues and dust from the
device as described under "Cleaning".
42

Assembly / disassembly

CAUTION:
Safety mechanisms prevent the simultaneous
assembly of the blender stick and the dough
hooks / beaters. Do not try to bypass them!
Assembly of dough hooks / beaters
NOTE:
• For safety reasons, the fixtures for the dough
hooks / beaters will lock once the blender
stick is attached.
• The dough hook with the ring marking on
its shaft must only be attached to the right
(larger) fitting of the mixer. The other dough
hook is intended for the left fitting. The two
dough hooks must not be attached without
following these instructions.
1. Make sure the switch (1) is at the "0" posi-
tion and the appliance disconnected from the
mains.
2. Push the ends of the dough hooks or beaters
into the respective fittings until they lock into
place. Slightly turning the accessories might
help facilitate the process of attaching.
Disassembly of dough hooks / beaters
Press the release button (1) to release the acces-
sories. This is only possible, when the switch (1) is
set to the "0" position or the blender stick symbol.
Assembly of the blender stick
NOTE:
• For safety reasons, the blender stick cannot
be used once the dough hooks or beaters
are attached.
• The fixture for attaching the blender stick (3)
is located on the bottom of the appliance.
1. Make sure that the switch (1) is set to the "0"
position and that the appliance disconnected
from the mains.
2. Slide the protective cover open in order to
expose the fixture.