Height Adjustment Of Brush - Texas A/S HS600TG Manuel D'utilisation

Operation
Before using the machine, remove all foreign objects from the vicinity. Stones, glass, branches and
similar items can damage the sweeping machine. Also check that all bolts are tightened.
Control oil level before starting the Engine.
Start the engine:
1. Open the fuel tap.
2. On a cold engine open the choker.
Note: By a hot engine choke is not required.
3. Turn thО throttlО МablО to "start" position.
4. Pull the recoil starter gently until you feel resistance in the rope. Then pull quickly and
energetic. Do not at any time let go of the recoil starter but glide it gently back and pull
again.
5. For 230V electric starter.
Plug the cord into electrical outlet and press the start button. After the engine is started
remove the plug from the socket alternatively pull the recoil starter to crank the engine.
6. Regulate the choker until the engine is running smoothly.
Stop the engine:
1. Set the throttle to minimum gas.
2. Turn the fuel tap to the"off" position.
Clutch Lever A - Forward and Reverse.
To operate the black clutch lever A in Fig. 5, the control stick must first be activated. By tilting the
control stick to the right or left side and then activate the black handle, the sweeper will move
forward or backwards. To change direction release the lever and set control stick to the new
desired direction and activate the lever.
Pay attention while reversing. It is important that the area is cleared, for any obstacle before
reversing. Never reverse the sweeper against a wall, tree or any other fixed obstacle.
Clutch Lever B - Forward
Upon activation of the upper clutch lever B in Fig. 5 the sweeper runs forward.
Clutch Lever C - Reverse
Upon activation of the lower clutch lever C in Fig. 5 the sweeper runs revers.
Clutch Lever - Activation of brush.

To operate the black brush lever D1 in Fig. 5, the control stick must first be activated. By
tilting the red stick completely to the right and then push the lever down activates the brush.

To operate the red brush lever D2 in Fig. 5, push the handle.
The sweeper is equipped with a "dead man's handle", once released the brush and drive will stop
immediately.

Height adjustment of brush

When the brush becomes worn, it might be necessary to adjust the proximity of brushes to the
working surface. To adjust the height of the brushes follow figure 6:
Read the instruction manual for the engine, before use.
REMEMBER TO FILL ABOUT 0,6 L WITH
12
IMPORTANT !
ENGINE OIL SAE-30
BEFORE START!
IMPORTANT !