Installation - Proline CDEP70-E Notice D'utilisation

34
tainer at the community waste disposal fa-
cilities.
Environmental tips
• In the dryer, laundry becomes fluffy and
soft. Fabric softeners are not therefore
needed when washing.
• Your dryer will function most economical-
ly if you:
– always keep the ventilation slots on the
base of the dryer unobstructed;

Installation

Appliance positioning
• It is recommended that, for your conven-
ience, the machine is positioned close to
your washing machine.
• The tumble dryer must be installed in a
clean place, where dirt does not build up.
• Air must be able to circulate freely all
round the appliance. Do not obstruct the
front ventilation grille or the air intake
grilles at the back of the machine.
• To keep vibration and noise to a mini-
mum when the dryer is in use, it should
be placed on a firm, level surface.
• Once in its permanent operating position,
check that the dryer is absolutely level
with the aid of a spirit level. If it is not,
raise or lower the feet until it is.
• The feet must never be removed. Do not
restrict the floor clearance through deep-
pile carpets, strips of wood or similar.
This might cause heat built-up which
would interfere with the operation of the
appliance.
Important! The hot air emitted by the
tumble dryer can reach temperatures of up
to 60°C. The appliance must therefore not
be installed on floors which are not resistant
to high temperatures.
When operating the tumble dryer, the room
temperature must not be lower than +5°C
and higher than +35°C, as it may affect the
performance of the appliance.
Warning! Should the appliance be
moved, it must be transported
vertically.
Warning! The appliance must not be
installed behind the lockable door, a
sliding door or a door with a hinge on
– use the loading volumes specified in
the programme overview;
– ensure you have good ventilation in the
installation room;
– clean the filter after each drying cycle;
– spin the laundry well before drying.
Energy consumption depends on spin-
ning speed set in washing machine.
Higher spinning speed - lower energy
consumption.
the opposite side to that of the
appliance.
The feet must never be removed. Do not
restrict the floor clearance through deep-
pile carpets, strips of wood or similar. This
might cause heat build-up which would in-
terfere with the operation of the tumble dry-
er in such a way that the full opening of the
tumble dryer door is not restricted.
Ensure min. 5cm free space around the ap-
pliance.
Removing transport safety packaging
Caution!
Before use all the transport packaging must
be removed.
1. Open loading door
2. Pull off adhesive strips from inside ma-
chine on top of drum.
3. Remove foil hose and polystyrene pad-
ding from the machine.
Electrical connection
Details on mains voltage, type of current
and the fuses required should be taken
from the type plate. The type plate is fitted
near the loading aperture (see "Product de-
scription" chapter).