Kobra K240.1 Mode D'emploi page 9

If you have any problems with your shredder check the symptoms and solutions outlined below.
If this fails to solve the problem contact the nearest KOBRA agent.
Never open the head of the shredder to try to repair it. You risk electrocution and void your warranty.
PROBLEM WHAT YOU SEE
The shredder won't - Light (S) fails to come on
start
- Red light (L) comes on
- Light (S) comes on
Shredder never - Light (S) on, cutting
stops working. knives working
Notable reduction - Capacity lower than
in shredding when knives are oiled
capacity
i : -
n aCCordanCe witH direCtive
-
direCtive
-
direCtive
t : elComan Srl
He manUfaCtUrer
via GoriZia,9
20813 BoviSio maSCiaGo (mi) - italY-
d
eClareS HerewitH tHat tHe followinG paper SHredderS ComplY witH tHe StandardS of tHe
KoBra : K 240.1 , 260.1 , 300.1 , 300.2
SerieS oBra
a :
pplied StandardS
en 60950-1:2006/a11:2009/a1:2010/a12:2011/a2:2013
en 55014-1 :2006+a1 :2009+a2 :2011
en 55014-2 :1997+a1 :2001+a2 :2008
B m , 15.01.2020
oviSio aSCiaGo
a.de roSa
t o
eCHniCal ffiCe
TROUBLE SHOOTING
CAUSE
- Switch position (H)
- Power cable is not plugged in
properly
- There is no power to the sh-
redder
- Door (C) not closed properly
- Bag is full
- Motor in heat protection
mode
- Material and/or dirt on or
between electronic eyes
- Cutting knives need oiling
D
eclaration of
lvd 2014/35/eU
2011/65/eU r HS
o
2014/30/Ue
ACTION
- Flick the switch (H) to the (I) position
- Check plug is inserted into socket
properly
- Check socket is switched on
- Close door properly
- Empty bag
- Wait 15 minutes for motor to cool
down
- Remove deposit from electronic eyes
or free electronic eyes
- Clean electronic eyes with a brush
- Oil the cutting blades manually
c
onformity
lvd 2014/35/eU
EN 61000-3-2 :2014
EN 61000-3-3 :2013
9 KOBRA 240.1, 260.1, 300.1, 300.2