Sigma 300 Compact Manuel D'instruction page 19

Connection/disconnection of water cooling
(MIG/MAG)
The water cooling
protection of the watercooled torch. The water cooling
will automatically be activated when welding is started
and stops automatically 3 minutes after welding has
been completed.
Configuration:
The following possibilities will be displayed after a long
pressure (> 5 secs) on the
0 = Water cooling disconnected
1 = Water cooling connected (factory setting)
Turn the right control knob until the requested number
is displayed. Press on the right control knob or the
key pad to accept the chosen parameter.
When a MIG Manager
automatically control the water cooling function and
disable this configuration.
function will ensure
- key pad:
®
is connected, it will
-
19