Kasco 2400EVX Guide D'utilisation page 23

4400EVX only
6. Secure the bottom
screen to the float with
the screen clip and
hardware.
7. Turn upright. Secure
power cord to rope hole
2400EJ
3400EJ only
8. Choose Nozzle. Push nozzle
into cone and twist the 3 tabs to
lock into the nozzle plate.
9. If ready to install in the pond, go to Installation instructions.
13. 3/8" bolt
14. 3/8" washer
15. bottom screen clip
16. 3/8" nut
DO NOT SCALE DRAWING
UNLESS OTHERWISE SPECIFIED
C.A.D. GENERATED DRAWING
DIMENSIONS ARE IN INCHES.
THIS DOCUMENT HAS BEEN ISSUED
DIMENSIONS IN [ ] ARE MILLIMETERS.
FOR ENGINEERING INFORMATIONAL
TOLERANCES ON:
PURPOSES ONLY. ANY REVISIONS
.X .02 [.508] .XX
TO THE CONTENT OF THIS DOCUMENT
MUST BE INCORPORATED INTO THE
.XXX .005 [.127] ANGULAR
ORIGINAL CAD FILE.
The two prongs
on the clip should
straddle a wire on
the screen
With Strain Relief
DWG. NO.
OR
Shipped with Sequoia nozzle preinstalled
DO NOT SCALE DRAWING MATERIAL:
UNLESS OTHERWISE SPECIFIED
C.A.D. GENERATED DRAWING
DIMENSIONS ARE IN INCHES. VALOX 357
THIS DOCUMENT HAS BEEN ISSUED DIMENSIONS IN [ ] ARE MILLIMETERS.
BLACK
FOR ENGINEERING INFORMATIONAL TOLERANCES ON:
PURPOSES ONLY. ANY REVISIONS
FINISH:
.X .02 [.508] .XX .010 [.254]
TO THE CONTENT OF THIS DOCUMENT
CLEAN
MUST BE INCORPORATED INTO THE
.XXX .005 [.127] ANGULAR 0.5
ORIGINAL CAD FILE.
FREE OF FLASH
THIS DRAWING CONTAINS PROPRIETARY
THIRD ANGLE PROJECTION INFORMATION AND SHALL NOT BE USED, TITLE:
REPRODUCED OR DISTRIBUTED WITHOUT
NOZZLE, SEQUOIA
THE PRIOR WRITTEN CONSENT OF
KASCO MARINE, INCORPORATED 3400J 4400J
MATERIAL:
AS NOTED ABOVE
X
FINISH:
.010 [.254]
NONE
0.5
16
13
Without Strain Relief
3400J SERVICE
431230
DWG. NO.
800 DEERE ROAD
PRESCOTT, WI 54021-1241
SCALE: 1:2 SHEET 1 OF 1
431230
800 DEERE ROAD
14
15
14
7