Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
Glass wall surface mounting instructions:
Start by cleaning glass wall surface with alcohol and let the surface be completely dry.
Recommended room temperature during this operation min 15°C.
1
Apply an horizontal adjusted tape on the glass wall as a guide for the adhesive foil.
Height from floor to centre of device approximately 1500 mm.
2
Remove the protective film partly from the glass wall adhesive foil.
3
Press the foil on to the glass wall with a force of approximatly 3 kgf. Use a rubber roller or
scraper for this operation. Make sure to remove any trapped air bubbles.
4
Remove protective film from the mounting bracket.
5
Use guides on foil to make sure bracket is in line with glass wall sticker.
6
Attention: The glue will bond immediately, and can not be remounted.
7
Press mounting bracket into glass wall foil for 20 seconds by a force of approximately 6 kgf.
Leave bracket on glass wall for 20 min before final assembly.
8
Route the cables on the glass wall using adhesive cable channels.
9
Mount ERM device on the bracket and secure it with the safety screw.
~1500 mm
For latest instructions go to: www.evoko.se/support
8
9
6
1
2
3
4
IMPORTANT!
Read safety instructions carefully before using the mounting instructions.
7
5
6
7
Kg
Kg
Kg
20
20
20
IMPORTANT!
For more information about the adhesive
foil (3M), please visit www.evoko.se/support
Publicité
Table des Matières
