Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
Standard wall mounting instructions:
1 Use the template to mark out hole positions for the mounting bracket. Height from floor to
centre of device approximately 1500 mm.
2 Drill the holes for the mounting bracket. Use two to four screws depending on the structural
capacity of the wall. Choose a screw type that is suitable for the type of wall concerned.
Note! Use 2 - 4 screws depending on the structural capacity of the wall. Always drill holes
and use suitable plugs for wall types such as concrete, plaster etc. Choose a screw type that
is suitable for the type of plug and wall concerned. Use screws with a diameter of 4 - 5 mm
and minimum length of 35 mm. If uncertain always contact a specialist or dealer for
assistance with wall mounting.
3 Mount the bracket to the wall with the screws and use a spirit level to adjust it horizontaly.
The mounting bracket is attached to the wall and holds the device. The slot-holes can be used
for final horizontal levelling.
Note! Do not remove the protective film on the back of the mounting bracket.
Note! "The sticky surface" should only be used for glass wall mounting.
4 Route the cables through the wall (A) or on the wall (B) using cable channels.
5 Mount ERM device on the bracket and secure it with the safety screw.
For latest instructions go to: www.evoko.se/support
IMPORTANT!
Read safety instructions carefully before using the mounting instructions.
4
1
A
B
~1500 mm
9.00
A
Ø20.00
(mm)
4
2
3
5
5
Publicité
Table des Matières
