Bruder Mannesmann Werkzeuge 99448 Notice D'utilisation page 17

range and then to reduce the range, in
order to achieve a proper test-reading.

Place the test prods to the spot mark
and the value is shown on the display.
Direct voltage (DCV / V

Connect the black cable to "COM"-hub
and the red measuring-cable to the "V"-
hub.

Position the center-switch in the area
"V " to the required range. If the
expected measured value is unknown,
you have to start by using the highest
range and then to reduce the range, in
order to achieve a proper test-reading.

Place the test prods to the spot mark
(observe the correct polarity!) and the
value is shown on the display
Alternating current (DCA / A~)

Connect the black cable to "COM"-hub
and the red measuring-cable either to
the" mA/Ω/BATT"-hub (upto 200mA) or
to the "10A"-hub (upto 10A).

Position the center-switch either in the
area "A~" to the required range or to the
value "10A".

Place the test prods to the spot mark
(observe the correct polarity!) and the
value and polarity are shown on the
display ( polarity of the red cable is
positive +).
)
.