HAEGER Styler Mode D'emploi page 7

10w
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

For short hair
Back of the neck
1. Start from the middle of the back of the neck holding the clipper against the
head with the TEETH UPWARDS. Keep the clipper resting against the head and
cut a little bit at a time.
2. When cutting, gradually raise the head of the clipper towards you. Continue
cutting on the back of the head from the base of the neck up to above the ears.
Sides
We recommend you use one of the smallest comb accessories (3 or 6mm).
1. Trim the sideburns and the area around the ears in an upward direction.
Top
We recommend you use one of the largest comb accessories (9 or 12mm).
1. Begin cutting from the FRONT of the head and gradually move towards the
BACK.
2. Remember that it is better to leave the hair a bit longer in the first haircuts until
you get used to the length of each position.
With Scissors
1. Lift the lock of hair to be cut using the comb or your fingers and cut above them.
Always start from the front backwards, gradually cutting the hair shorter. Comb
it frequently to detect any irregularities of length and to remove hair you have
already cut.
Finishing Touch
1. To achieve a straight line at the sideburns and around the ears, remove the
comb accessory, hold the clipper at a right angle to the head, upside down with
the blades touching the skin, and move it downwards.
2. We remind you that using the hair clipper without the comb accessory will crop
the hair.
Care and Cleaning
– It is essential to switch off the unit and remove the plug from the wall socket
before cleaning and oiling.
– To avoid the risk of electric shock, the appliance must not be immersed in liquid
or even allowed to come into contact with liquid.
– Do not use abrasives or harsh cleaning solutions.
Instructions for use
English
5

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hc-010.008a

Table des Matières