HAEGER Styler Mode D'emploi page 6

English
Use
Before starting to cut
1. Check that the clipper is clean and that there are no traces of hair between the
blades, as this could prevent it from working properly.
2. Sit the person whose hair you are going to cut so that their head is level with your
eyes.
3. Untangle the hair and comb it in its natural direction.
To start cutting
1. Remove the blade shield and attach the comb accessory you want to use. The first
time you use the hair clipper we recommend you start with the largest comb
accessory (12mm), then if you want a shorter cut, choose a smaller comb
accessory (9, 6 or 3mm).
•
The first time you use each comb accessory, cut a small amount of hair until
you get used to the length achieved using each guide comb.
•
The comb accessory adjustment lever will allow you to adjust the length of the
cut without needing to change the comb accessory. When it is in the highest
position you will get the shortest cut, and when you gradually move the lever
down the cut will get longer.
2. Place the ON/OFF switch in the ON position.
Notes:
– When cutting longer hair, use a push-on comb or cut hair above a
normal comb. Always start with the largest push-on comb, as this
will help you to get a feel for cutting the hair to the desired length.
– For shorter hair-cuts, follow-up with a smaller push-on comb or
without any comb attachment.
– Cut from bottom to top with the trimming comb lying against the
head; lead the appliance upwards through the hair, moving it
gradually away from the head at the same time.
– For a shaped cut, reverse the appliance and shorten the hair from
top to bottom without a push-on comb.
4 Instructions for use