Main Components - HAEGER Styler Mode D'emploi

Main Components

1. Blade shield
2. Comb accessory adjustment lever
3. ON/OFF switch
4. Comb accessory 3 mm
5. Comb accessory 6 mm
6. Comb accessory 9 mm
Short-time operation
The appliance is designed to be operated for a short period, i.e. the hair trimmer can
be operated without interruption for a maximum of 10 minutes. Operation can be
resumed after the appliance has cooled down for approximately 20 minutes.
Adjusting the cutting length
– The side adjusting lever (2) allows smooth adjustment of the cutting length from
approx. 1 to 1.6 mm, even during operation.
– The push-on combs provided extend the range of the cutting length and are fitted
onto the trimming comb. After use, remove the attachment at the back and lift it
off.
Recommendations
•
We recommend that the hair should be DRY when cutting with the clipper for
better control over the amount of hair cut.
•
Use SHORT STROKES. Do not complete a whole side with one stroke.
•
Remember to comb the hair frequently as you are cutting it.
•
To cut the HAIR EVENLY, allow the clipper ADVANCE SMOOTHLY through the hair.
Do not attempt to force it.
•
It is better to cut a little than too much. Begin with the maximum cutting length
position (12 mm).
•
We recommend that you make a note of the cutting level selected each time, so
that you can repeat the same hairstyle on other occasions if you wish.
Instructions for use
7. Comb accessory 12 mm
8. Lubricating oil
9. Cleaning brush
10. Barber comb
11. Scissor
English
3