Using The Tuner - Alesis WILDFIRE15 Guide D'installation Rapide

Selecting, Editing and Storing Programs
1. In PLAY mode, use the Program Up and Down buttons, footswitches or VALUE knob to select a
program.
2. Turn the EFFECT knob to the module or parameter you wish to edit.
3. Turn the VALUE knob to change the value of the module or parameter.
4. To store your changes, press the VALUE knob and then turn the knob to select a store location. Press
the VALUE knob again to store the program.

Using the Tuner

1. In PLAY mode, activate the tuner by pressing the Program Up and Down buttons or both footswitches
at the same time to enter Bypass mode, or hold them down for more than half a second to enter Mute
mode.
2. Play the open string you wish to tune. Use the following guide when tuning:
The bottom four segments
rotate counterclockwise if pitch
is low. The top four rotate
clockwise if pitch is high. An 8
means pitch is in tune.
The twelve possible
pitches (a decimal point
indicates a sharp):
Visual Guide to Tuning
Low
= no pitch detected
In tune High