Kenwood KCA-S210A Mode D'emploi page 3

■ If you want to connect a stack CD changer
Centre unit
Disc changer
2CAUTION
• Connect it to a centre unit belonging to Group C or Group D.
• Connect the stack CD changer to the terminal labelled TO CHANGER 2.
• The KDC-C810 cannot be connected.
• Up to two disc changers can be connected.
• The O-N switch on the disc changer and the disc player should be set to "N". If you set it to "O", the
equipment will not function correctly.
• The total length of the cable between the units should not be more than 13m.
Centre unit
• If the voltage is low and the internal temperature of the switching unit is low, switching may fail to work
properly in some cases.
• The AUX switch on the stack CD changer should be switched "OFF" before using the equipment. The
AUX terminal on the KCA-S210A switching unit is the one that should be used.
Connection cable3
Connection cable (supplied with the Disc changer)
Connection cable (supplied with the stack CD changer)
KCA-S210A
Not more than 13m
TO
CHANGER 1
H/U
TO TO
CONTROLLER H/U
Extension cable (CA-C2E:Optional)
Disc player
Stack CD changer
Stack CD Changer
To the external units
AV
IN
Switching unit1
(Rear side)
TO
TO
CHANGER 2
TO TO
Switching unit1
CHANGER 1 CHANGER 1 CHANGER 2
(Front side)
Disc Player
English
-3