Target Group; Accident Prevention; General Information - SATA dry jet 2 Mode D'emploi

Masquer les pouces Voir aussi pour dry jet 2:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 79
Content [Original Ver-
sion: German]
1.
General Information ............... 53
2.
Safety Instructions ................. 54
3.
Use ........................................ 54
4.
Description ............................ 54
5.
Scope of Delivery .................. 54
6.
Technical Design ................... 54
7.
Technical Data ....................... 55
8.
First Use ................................ 55
9.
Normal Operation .................. 56
11. Malfunctions .......................... 58
12. After Sale Service .................. 59
13. Spare Parts ........................... 60
Read first!
Read these operating instructions
thoroughly and carefully before
use. Comply with the safety in-
structions and danger warnings!
Always make sure that these oper-
ating instructions are kept with the
product or keep them easily acces-
sible for everyone at any time!

1. General Information

These operating instructions con-
tain important information for oper-
ating the SATA dry jet 2, hereinafter
referred to as dry jet gun. They also
describe use, care, maintenance,
cleaning and troubleshooting.
Operating instructions SATA dry jet 2

1.1. Target group

This operating manual is intended
for
■ Painting and varnishing profes-
sionals.
■ Trained personnel for varnishing
work in industrial and craftman's
workshops.

1.2. Accident prevention

As a basic principle, the gen-
eral and specific national accident
prevention regulations must be
heeded, together with correspond-
ing workshop and industrial safety
instructions.
1.3. Replacement, accessory
and wear-and-tear parts
Always only use original SATA
spare parts, accessories and wear
parts. Accessories not supplied by
SATA have not been tested and ap-
proved. SATA assumes no liability
for damage caused by the use of
non-approved spare parts, acces-
sories and wear parts.
1.4. Warranty and
liability
The SATA General Conditions of
Sale and Delivery and further con-
tractual agreements apply, if ap-
plicable, as well as the valid legisla-
tion at the time.
SATA is not liable in case of
■ non-adherence to the operating
manual.
■ use of untrained personnel.
■ improper use of the product.
EN
53

Publicité

Table des Matières
loading

Table des Matières