aquatechnik BBS 32 Manuel D'utilisation page 15

INSTRUCTIONS FOR USE
1. Remove the conical pin protection (E) and set the mechanical expander (G) of
the desired working diameter on the Coupling tool BBS 32, checking that it has
been screwed up to the stop.
NB1: In order to perform this operation, the
equipment must be in a rest position.
NB2: Check that the elastomeric adapter (G) is
mounted on the mechanical expander (H) and that no
tears or breaks are evident on the elastomeric
adapter.
The good shape of couplings is granted only if the
adapter is in a good condition (for adapter removal
and replacement, see "Replacing of the elastomeric
adapter").
Do not use grease, soap, lubricating or sliding products of any kind on the
elastomeric adapter (H).
Warning: When mounting the mechanical expander, make sure that the
equipment is not connected to the power supply source (battery or outlet).
2. Cut the pipe perpendicularly and with care, then insert the cap into it.
NB: To avoid damage to pipe heads, make sure that the shearing or pipe-cutting
blades are in good working order. blades are in good working order.
3. Insert the pipe into the mechanical expander (G) pushing it up to the stop.
Warning: The pipe must be in axis and parallel to the expander.
4. Press the starting button (B) until the coupling is made (the pipe will be
automatically released from the tool once such operation is over). The
equipment is now ready for the next coupling cycle. (Wait for the shut-off valve
return time, varying from 5 to 10 seconds.)
YES
BBS 32
(patented)
STOP
Picture 1
NO Picture 2
ENGLISH 15