Carat CARACOUP Série Mode D'emploi page 24

GB
13. Troubleshooting
HAVE YOUR TOOL REPAIRED BY A QUALIFIED PERSON ONLY
This electric tool complies with the relevant safety rules. Repairs should only be carried out by
qualified persons using original spare parts, otherwise this may result in considerable danger to the
user.
Faul
The machine does not work.
If lubrication does not arrive at
the disk with the pump running.
Motor gives off unpleasant odour.
Machine is difficult to start.
The machine is cutting out of
square.
Cause
The power supply cable is
damaged or not
connected.
No voltage in the socket.
Control switch is damaged.
The sprayer unit is clogged.
Water may have seeped through
inside the motor
Capacitor is damaged.
Motor bearings are damaged.
The tile supports are not at right
angles with the cutting disc.
The disc is not suitable for the
type of material to be cut.
24
Remedy
Press the plug firmly into the
properly power socket. Check the power
supply cable.
Have the socket checked.
Consult
replacement.
Dismantle the sprayer assembled
inside the disk cover and remove
any possible residuals.
Unplug the power supply cable
and consult local dealer.
Unplug the power supply cable
and consult local dealer.
Unplug the power supply cable
and consult local dealer.
Using a square, adjust the tile
supports to 90° in relation to the
cutting line of the disc.
Replace the disc with a more
suitable one.
local dealer for