Carat CARACOUP Série Mode D'emploi page 19

Remove the machine from the packaging with the
aid of the side carrying handles.
To place the machine in working position, proceed
as follows:
1) Remove the machine from the packaging with
the aid of the side carrying handles.
To place the machine in working position,
proceed as follows:
4
2) Lift the leg making it slide inside the relevant
slot.
5
3) Repeat the operation for the front part
(see picture 5).
4) Insert the tube-holder
(see picture 6).
rod in its seat
19
6
In case of machine disassembly, perform the
opposite operations.
CHECKING BEFORE USE
CAUTION!
THE CARACOUP
DESIGNED FOR WORKING
WITH WATER.
Before any cutting operation, make sure that the
water level inside the tank is correct.
7
CAUTION!
Before using the machine, check there is power
supply.
CAUTION!
ADJUSTMENT OF COOLING WATER
Through an on-off valve placed on the disk
protection, the water flow can be adjusted according
to the type of material to be cut.
An innovative cooling system makes it possible and
allows the disk to be always wet.
GB
MACHINE HAS BEEN
EXCLUSIVELY