Overheating Protection; Troubleshooting - Parkside PKH 2000 B1 Instructions D'utilisation Et Consignes De Sécurité

˜ Overheating protection
The product is equipped with overheating
protection . If the product overheats, the
heating element will turn off automatically .
However, the fan continues to run so that rapid
cooling is achieved . The product will turn on
again automatically once it has cooled down
properly .
WARNING! There is usually a reason for
m
overheating! It can indicate a fire hazard!
Check whether the product is giving off
sufficient heat:
– Is the product covered or is it too close to a
wall or other obstruction?
– Is the grid blocked in the front or at the
back?
– Is the fan blocked?
Rectify the problem if possible, or contact the
service hotline (see the section "Service") .
30 GB/IE
˜ Troubleshooting
Problem Cause
The power
plug
7 ] [
connected .
The product
cannot be
The socket-
turned on .
outlet does not
deliver any
voltage .
The heating
level switch
is not turned
on .
The product The
does not heat temperature
up . control
is set to the
lowest position .
The heating
element is
defective .
Solution
Connect the
power plug
[ 7 ]
is not
to a socket-
outlet .
Check the
house fuses .
Set the heating
level switch
4 ] [
[ 4 ]
to the desired
operation
mode .
Set the
temperature
control to
[ 3 ] 3 ] [
the highest
position .
Notify the
customer
service .