Deltaco DUR-900 Mode D'emploi page 34

Inverse/regular barcodes
Regular barcode: Dark image on a bright background. Inverse barcode: Bright image on a dark background.
Barcode inverse on: Read both regular barcodes and inverse barcodes. Barcode reverse off (default): Read regular
barcodes only. The scanner shows a slight decrease in scanning speed when barcode inverse is on.
Barcode inverse: On
W100210
1D symbologies
Code 128
Restore factory defaults of Code 128
WFFD990
UCC/EAN-128 (GSl-128)
Restore factory defaults of UCC/EAN-128
WFFD991
AIM 128
Restore factory defaults of AIM 128
WFFD992
Add-on barcodes EAN-8 / EAN-13 / UPC-E / UPC-A
In the examples: The parts without dotted lines are the base/standard barcodes while the parts surrounded by dotted lines
are the barcode add-ons. Examples:
When 2-digit add-on and 5-digit add-on are enabled, the scanner can scan barcodes both with add-ons (2 and 5) and
without add-ons (2 and 5). When both are disabled, the scanner will ignore the add-on part of the barcodes. The scanner
The same applies for EAN-8 / EAN-13 / UPC-E / UPC-A.
EAN-8
EAN-8 is 8 digits in length. The last digit is a check digit used to verify the integrity of the data.
Restore factory defaults of EAN-8
WFFD994
Barcode inverse: Off
Enable Code 128
W011601
Enable UCC/EAN-128
W011701
Enable AIM 128
W101610
33
W100200
Disable Code 128
W011600
Disable UCC/EAN-128
W011700
Disable AIM 128
W101600