Table des Matières
Publicité
Debug mode and factory default
The barcode setting "factory default" allows normal output. If you scan "debug mode", the barcode settings will be output to
the host when scanning barcode settings. When "debug mode" is enabled then barcode settings cannot be used to set the
scanner. When the scanner is re-powered (after being in "debug mode"), it will return to factory default. After it has returned
to factory default you can set the scanner with barcode settings.
Note: Please use the "factory default" setting with caution.
After scanning "factory default", the scanner will lose its current settings, and change to factory default settings.
For factory default settings and functions see the factory defaults table.
Debug mode
W401740
Communication Interface
Serial communication interface
The scanner provides TTL-232 serial communication interface and USB interface to communicate with the host.
Via the interfaces, it can receive data, control the instructions from the scanner, and modify the scanner's settings. The
Baud rate settings
Parameters
Serial Communication Type
Baud Rate
Check
Data bits
Stop bit
Hardware Flow Control
Baud rate: 9600
WFFD9D3
Baud rate: 2400
WFFD9D1
Baud rate: 38400
WFFD9D6
Baud rate: 57600
WFFD9D7
Baud rate: 115200
WFFD9D8
Factory default
WFFD980
Default
Standard TTL-232
9600
None
8
1
None
Baud rate: 1200
WFFD9D0
Baud rate: 19200
WFFD9D5
Baud rate: 4800
WFFD9D2
Baud rate: 14400
WFFD9D4
24
Publicité
Table des Matières
