Operation - BABYTREND HC05B Manuel D'instruction

OPERATION

TO FOLD HIGH CHAIR
The High Chair may be folded with the seat in
any of the height positions.
• Place seat in the desired height position.
15)
Place Seat Back in the most upright
position (Fig. 15).
• Squeeze the tray release handle and
16)
slide the tray out (Fig. 16).
• Hang the tray on the hooks located on
17)
the back of the rear leg (Fig. 17).
• Pull upward on the release levers
18)
(located on the sides of the frame) and
push the rear legs in the direction of the
front legs until folded (Fig. 18). Chair is
now ready to put away.
DO NOT allow your child to play around
a folded high chair as it may fall.
TO UNFOLD HIGH CHAIR
Read the Warning and see (Fig. 18), then
Reverse the steps above.
WARNING:
on the frame when the seat is
not attached. Do not use frame
as a foot stool. Potential pinch
point when opening the frame.
11
Copyright © 2018, Baby Trend ® Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Fig. 15
Tray Release located underneath tray
Fig. 16
Fig.17
DO NOT place
fingers here.
Do not sit
Fig. 18
TO REATTACH SEAT PAD
NOTE: Certain High Chair models are
packaged with the High Chair Seat Pad and
Seat Insert already attached to the Seat Back.
• Thread non-buckle end of Harness
19)
Straps called Harness Attachment
Tabs through the provided slots in
the Seat Fabric, Seat Insert, Seat
Back, and Seat Base (Fig. 19). When
Harness Attachment Tabs are through
the provided slots, rotate the Harness
Attachment Tabs 90 degrees. Make sure
that the straps are firmly in place.
• Loop the flap on the back of the pad
20)
over the top of the Seat Back. Connect
the Seat Pad to the Seat Back with the
two Elastic Loops. These fit over the
Attachment Tabs located near the top
harness slots (Fig. 20a).
• Insert the Harness Covers through the
Harness Straps (Fig. 20b).
Copyright © 2018, Baby Trend ® Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
OPERATION
Fig. 19
Fig. 20a
Fig. 20b
12