Scope Of Use - Rothenberger Industrial 030900 Mode D'emploi

030900_Anleitung_26 Sprachen:PRINT
FEATURES
1 Soldering iron adapter
with 2 soldering tips
2 14 mm Point burner
3 28 mm Turbo burner or.
22 mm Turbo burner
4 Burner tube
5 Handle with safety/economy valve
6 Propane regulator
6a Integrated seal (not in all versions / countries)
7 Burner wrench
8 Gas hose, inner diameter 4 mm, R3/8"
connector at both ends, length 2m (max
permitted length: 5 m)
9 Burner stand
10 250 g Copper soldering iron head with stand
11 Paint stripping attachment, width: 50 mm
12 22 mm Brazing burner
13 Safety lighter
14 Hose failure safety device (optional
accessory)
15 LPG refillable cylinder (not included in scope
of delivery)
15a Integrated seal (not in all versions / countries)
The pictures are for illustrative purposes only, the actual device may vary slightly. The manufacturer reserves
the right to make changes without notice.

SCOPE OF USE

This turbo brazing set is suitable for soldering and brazing without the use of oxygen and for warming,
shrinking and burning off. Use of the product for any other purpose and / or modification of the product
count as misuse and can be highly dangerous and is forbidden.
This appliance may only be used with propane or wiith propane-butane mixtures and with the provided
pressure regulator. This appliance shall only be used with LPG refillable cylinders. It can be dangerous
to connect the burner to other types of gas containers.
Commercial users must employ a hose failure safety device (Art. No. 035925E) when using the appliance.
This is also recommended for home users. The device can be purchased from the manufacturer.
Scope of use for each attachment:
- Solering adapter with 2 soldering tips (Parts diagram, no. 1): for use as as soldering iron.
- Point burner (Parts diagram, no. 2): for fine, precise soldering jobs.
- Turbo burner (Parts diagram, no. 3): for general brazing work and, due to the very short flame particularly
suitable for shrinking work and for capillary soldering during sanitary and heating installation work.
- 250 g Copper soldering iron head (Parts diagram, no. 10): specially designed for soldering guttering,
drain pipes and copper, steel and zink roofing up to 1 mm thick.
- 50 mm Paint stripping attachment (Parts diagram, no. 11): for stripping paint
- 22 mm Brazing Burner (Parts diagram, no. 12): Standard brazing burner, for general brazing work and
for warming and burning off
19.10.2016 10:21 Uhr
7
Seite 7