Transport; Storage; Care And Service; Troubleshooting Guide - Kärcher HV 1/1 Bp Mode D'emploi

Cleaning mode
1. Perform cleaning.
Draining the dirt receptacle
Empty the dirt receptacle regularly, but at the latest
when the suction performance decreases.
Note
Large accessories, such as suction pipes, should be re-
moved before removing the dirt receptacle to facilitate
handling.
1. Press the dirt receptacle release mechanisms on
both sides.
2. Pivot the dirt receptacle upwards.
3. Remove the cartridge filter from the dirt receptacle.
4. Empty the dirt receptacle.
5. Reinsert the filter elements.
6. Reinsert the dirt receptacle until it latches into place.
ATTENTION
Risk of damage!
Ingress of dirt destroys the suction turbine.
Do not operate the device without the filter element.
Turn the suction hose port
To facilitate handling, the suction hose port can be rotat-
ed.
1. Press the release mechanism of the suction hose
port.
2. Turn the suction hose port in the desired direction
until it latches into position.
Each time after use
1. Empty the dirt receptacle.
2. Charge the battery pack.
Storing the device
1. Store the device in a dry room and secure it against
unauthorised use.

Transport

CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during transporta-
tion.
1. When transporting the device in vehicles, secure it
to prevent it from slipping or overturning in accord-
ance with the respective valid guidelines.

Storage

CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during storage.
The device may only be stored indoors.
1. Press the unlocking button and remove the battery
pack to prevent discharge.

Care and service

DANGER
Risk of injury!
Injuries due to touching moving parts.
Switch off the device.
Remove the battery pack.
Cleaning/replacing the filter element
1 Dirt receptacle
2 Pre-filter
3 Cartridge filter
1. Unlock and remove the dirt receptacle.
2. Pull the cartridge filter out of the dirt receptacle.
3. Pull the pre-filter off the cartridge filter.
4. Clean the filter element or replace if necessary.
ATTENTION
Risk of damage!
Damage to the filter elements during mechanical clean-
ing.
Carefully clean the filters by gently knocking the dirt out.
Do not expose the filter area to any mechanical loads
and replace the filters if damaged.
Do not operate the device without the complete fil-
ter elements.

Troubleshooting guide

DANGER
Danger of electric shock
Injuries due to touching live parts
Switch off the device.
Remove the battery pack.
Suction turbine does not start up
Discharge battery pack.
1. Charge the battery pack.
Battery pack not correctly inserted into the battery hold-
er.
1. Press the battery pack into the holder until it locks in
place.
Battery pack at the end of its life
1. Replace the battery pack.
Observe the instructions in the operating in-
structions of the battery pack!
Suction power decreases
Dirt receptacle full.
1. Empty the dirt receptacle.
Filters dirty.
1. Clean the filter elements.
No or insufficient suction performance
Eco function is switched on.
1. Switch the Eco function off for full suction power.
Accessories clogged.
1. Remove clogging from the suction nozzle or suction
pipe.
The device stops during operation
Discharge battery pack.
1. Charge the battery pack.
Battery pack overheating protection has triggered.
1. Allow the battery pack to cool down.
English 7