Freehand Cutting - Greencut SRM120C Manuel D'utilisation

IGNITION AND SPEED CONTROL
1. To turn on the machine, press the green ON ("I) button.
2. To switch off the machine: Press the red OFF ("O") key.
3. The speed is adjustable between 400 and 1600 SPM. Turn the speed control clockwise to increase speed;
turn counterclockwise to decrease speed.

FREEHAND CUTTING

1. Lift the protective foot of the blade (1) by loosening the height
adjustment button (2).
2. Place the workpiece against the blade and place the blade guard foot
against the top surface of the workpiece.
3. Secure the blade guard foot (1) by pressing the height adjustment button
(2).
4. Remove the workpiece from the blade before turning on the machine.
5. Slowly insert the workpiece into the sheet by guiding it and pressing it
against the table.
6. When the cut is complete, move the edge of the workpiece beyond the
blade's protective foot.
ANGULAR CUT (BEVELED)
1. Move the blade guard foot to the highest position by loosening the height adjustment knob (1). Squeeze
the knob again.
2. Tilt the table to the desired angle by loosening the table bevel lock button (2). Move the table to the desired
angle using the degree scale and pointer (3).
3. Press the bevel lock button on the table (2).
4. Loosen the blade guard screw and tilt the blade guard to the same angle as the table. Retighten the blade
guard screw.
5. Place the workpiece on the right side of the blade. Lower the blade guard foot against the surface by
loosening the height adjustment knob. Squeeze the knob again.
6. Slowly insert the workpiece into the sheet by guiding it and pressing it against the table.
7. When the cut is complete, move the trailing edge of the workpiece beyond the blade guard foot.
1
2
3
3 3
57
1
2
EN