Personalising The Autoclave; Installation Date; Preheating - ACteon QUAZ 17 l Manuel D'utilisation

Press on the icon according to the option you would like to change

4.3.6 PERSONALISING THE AUTOCLAVE

On this screen the user can personalise the autoclave with the autoclave identification data and the preheating, and have access to the latest memorised cycles, the counter and the
maintenance RESET.
4.3.6.1 LAST CYCLES
This option enables the user to see and retrieve the information on the last 50 cycles.
When the cycle is displayed it can be printed by pressing the printer icon.

4.3.6.2 INSTALLATION DATE

The QUAZ autoclave automatically sets the date of the first sterilisation cycle out of the factory as the date of installation.
The user cannot modify this date; it is just for informational purposes.

4.3.6.3 PREHEATING

To activate the 'Preheating' operation, press on the icon
Once the 'Preheating' operation is activated the sterilisation chamber will heat up until it reaches approximately 45ºC. The temperature signal on the touch-screen will start to flash.
If a cycle is not started after 45 minutes the autoclave stops heating up. The 'Preheating' option will stay on and it will heat the sterilisation vessel up again after each cycle or every time
the autoclave is switched on.
Press the icon to disable the 'Preheating' operation
IMPORTANT: The 'Preheating' operation heats up the sterilisation chamber before starting the cycle so the cycle is carried out faster.
Brightness
Select a value from
Exit screen
See the cycle information
Print the cycle
Contrast
Sound signal 'BEEP'
Exit screen and save
settings
0 to 10
Selected cycle
Move the cursor to the
required cycle
See the selected cycle
13