FAR TI60ST333/CH Manuel D'utilisation page 29

Instruction Boost Mode
Activate boost mode
1. Touch control command to display the power level from 1 to 9, except level 0.
2. Touch BOOST command
Cancel Boost mode
1. Touch BOOST command (when the symbol P is still flashing) or "-" button to cancel the BOOST mode. The
cooking returns to its initial power setting.
2. Touch the keys "-" and "+" simultaneously, the cooking zone turns off and the BOOST mode is
automatically cancelled.
- BOOST mode can be activated for any cooking zone
- The cooking zone returns to its initial value after 5 minutes
ATTENTION :
- If initial value is « 0 », after 5 minutes it goes back to level « 9 » in order to maintain sufficient power to
eventually reach boiling water level if this is the case that of use. Therefore, it is necessary to watch out
the power of the cooking zone at the end of BOOST mode.
- Using BOOST mode requires power limitation to allow the selected cooking zone to reach the sufficient level.
- The limitation is set to the left area only: cooking zone 1 and 2, however the cooking zone
number 3 is not affected by the limitation of power.
-
If the cooking zone number 1 is in BOOST mode, the cooking zone number 2 automatically
goes to level 2 and remains at this level even after Boost mode in 5 minutes, and vice versa.
- To keep the cooking zone at the selected level simultaneously with another cooking zone
with BOOST mode selected, it is better to use the cooking zone number 1 or 2 at the left
side and the cooking zone number 3 at the right side.
. " P" will pop up and the power reaches its maximum during 5 minutes.
OR
.
29