FAR TI60ST333/CH Manuel D'utilisation page 27

Automatic safety
Over-temperature protection
A sensor situated inside the induction cooking permanently measures the temperature at the surface of the
induction cooking. If a high temperature is detected, the induction cooking will automatically turns off. When the
temperature at the surface of the induction cooking is back to normal, the induction cooking becomes operation-
al.
Residual heat warning
At the end of the cooking, the induction cooking remains hot, the light '' H " indicates which cooking zone remains hot.
Automatic disconnection
The induction cooking is programmed to turn off automatically if no operation is done during a set of time (for
instance, if the user forgets to turn off the device).
The induction cooking is programmed to turn off automatically according to the level of power previously selected.
The waiting time is noted below:
Level of power
Maximum operating time without
action (hour)
Detection of small objects:
When inappropriate cooking vessel, non-magnetic or small objects (such as knives, forks, spoons or keys) are left
over the induction cooking, the following indicator
automatically after 1 minute.
Water detection
The induction cooking is programmed to turn off automatically when a large amount of water overflowing from a
cooking vessel and comes into contact with the touch-sensitive keys. Soak up and correctly clean the induction
cooking to return to operation. Press any key 10 seconds to reset the induction cooking.
Instructions for using
Key lock (child safety)
To prevent any unintentional changes, you can lock the setting.
When the lock is activated, all buttons are disabled except the button ON / OFF (5).
1. To activate the lock, press the lock button
2. To deactivate the lock, make sure the induction cooking is in operation. Press a few seconds the button
until it turns off. You can again use the induction cooking.
Note: When the lock is active only the button On / Off
use of the induction cooking, it is required to deactivate the lock function by following the indication number 2.
Timer Operations
The timer can be used in two different ways:
1. Simple timer: Set the timer BEFORE selecting the power of the cooking zone. In this case, at the end of the
countdown, the timer will ring but will not stop the operation of the induction cooking.
2. Set timer to stop the selected cooking zone. Select the power of the cooking zone BEFORE setting the timer.
The timer is operational for all cooking zones independently.
Timer display:
Set timer
' '
1 2 3 4
8 8 8 4
will be displayed. The induction cooking therefore turns off
(3) until the induction cooking displays "
(5) can be used to turn off the induction cooking. To make
27
5 6 7 8
4 4 2 2
Lo
".
The display shows the selected time and
the remaining time
9
2
(3)