Noise Emission Specifications; Scope Of Supply; Safety Devices - Mafell PSS3100SE Notice D'emploi

2.4 Noise emission specifications

Following EN ISO 3746, EN ISO 11202 and Annex P of ISO 7960, noise emission was determined with the
following deviations from these standards:
Saw blade:
Workpiece:
Feed speed:
Working noise measurement:
Microphone position work station:
Machining
The included uncertainty K amounts to 4 dB.
The values stated do not take into consideration any possible series variances and are not suitable for
determining the rating levels, as these fluctuate in dependence on the time in service, the respective type of
machining and the environmental influences. The noise rating level can therefore only be determined on an
individual basis at the machine user's position.

2.5 Scope of supply

Board sawing system PSS 3100 SE complete with:
1 guide rail extension
1 carbide-tipped circular saw blade Ø 160 mm (6 ¼ in.), 24 teeth
1 riving knife / splitter thickness 1.2 mm (3/64 in.)
1 bracket handle
1 service tool in retaining bracket on the motor casing
1 anti-friction agent
1 operating manual
1 folder "Safety Instructions"

2.6 Safety devices

Danger
These devices are required for the
machine's safe operation and may
not be removed or rendered
inoperative.
The machine is equipped with the following safety
devices:
carbide-tipped circular saw blade Ø 160 mm (6 ¼ in.), 32 teeth
uncoated chip board 16 mm (5/8 in.), length 1200 mm (47 in.), original
width 700 mm (27 9/16 in.) and cutting of 40 mm (1 9/16 in.) wide strips
17 m/min (55.8 ft/min.)
Cutting stroke + reverse motion of the saw unit with turned on saw blade
drive
300 mm (11 3/16 in.) behind the machine's short side, at the centre of
the machine, 1.5 m (59 in.) above the floor
Sound power level
108 dB (A)
Workplace-related emission value
97 dB (A)
- Stationary guards around the saw blade.
- Large bearing faces of the guide rails with slip
guards.
- Operation of infeed and saw blade drive from one
operating point.
- Index mechanisms without catch
- Riving knife / splitter
- Dust extractor
-23-