Medisana MTM Mode D'emploi page 19

3.4
Setting time
and date
4.1
Fitting the cuff
4.2
Correct position
for taking readings
3 Getting Started / 4 Operation
You can activate the 3/MAM-mode by holding down the MODE button
for several seconds. The symbol for the selected memory will start to flash.
After another short press of the MODE button
flashing text "OFF" will appear in the display
4 , you can now choose between switching the 3/MAM-mode ON and OFF.
When the 3/MAM-mode is activated, an
You can set the date and time by hol-ding down the MODE button
several seconds. The symbol for the selected memory will start to flash. With
two more short presses of the MODE button
start to flash in the display. Change the year by pressing the SET button
Then use the MODE button
and time. You can change the values of each using the SET button
First attach the free end of the cuff's
8 on the unit. Open up the cuff and slip it over the bare left upper arm just
above the elbow region. If wearing tight clothing, ensure that the circulation in
the arm is not impaired when rolling up the sleeve. Please ensure that the cuff
buckle is not positioned directly over the artery, as this can result in an
incorrect blood pressure reading.
The hose should run along the centre of the inner arm towards the palm of the
hand. Ensure that the cuff itself is not twisted in any way.
Fasten the pressure cuff in such a way that it fits tightly but does not constrict
the arm. Do this by passing the end through the buckle, pulling it tight and
attaching it to the Velcro fastener.
• Take readings while in a seated position.
• Relax your arm and rest it lightly on a surface such as a table. Relax during
the measuring process: do not move or talk, as this can affect the results.
5
3 . By pressing the SET button
will appear in the display.
5 , the number of the year will
5 to move on to the month, day of the month
1 air hose to the designated connector
GB
5
, a flashing and the
5 for
4 .
4 .
15