Safety Precautions - Maximex 9933161500 Mode D'emploi

Safety precautions:

1. The lamp may be plugged into a properly wired wall outlet only.
Before plugging it in, make sure the indicated voltage of the lamp
is the same as your local supply.
2. To prevent fire or electric shocks, do not put the lamp close to
heat sources. Also keep it away from moisture.
3. The lamp cable may not be damaged. Do not attempt to repair
any damage on your own.
4. Do not disassemble the lamp.
5. Adjust the lamp at its joints in the appropriate direction only.
6. Do not look straight into the light source – the light is very bright!
7. Be careful when adjusting the lamp as there is a squeezing
hazard at its joints.
In case of the following events please disconnect the lamp
from its electricity source and do not use it again:
- Defective mains plug and/or cable
- The lamp foot has become moist or wet
- Damage on the cases and/or joints
- Formation of smoke or sparks
- Unusual flickering or defective LED unit
Maximex
Art.: 9933161500
Maximex GmbH & Co. KG
Bentheimer Str. 239
48529 Nordhorn
service@maximex.eu
Adjustment of the
5 levels of brightness
Adjustment of the
3 colours of light
(cold/warm/natural)
Press the ON/OFF switch
for 2 seconds for the
standby LED (ON/OFF)
USB-port
Standby LED
Batteries, rechargeable batteries and electrical devices must not be disposed of
with the normal household waste! All consumers are legally obliged to submit all
batteries, rechargeable batteries and electrical devices, whether they contain
pollutants or not, to a collection point in their community or district or to return
them to a dealer, so that they may be disposed of an environmentally compatible
way. Only submit batteries and rechargeable batteries in a discharged state!
Maximex GmbH & Co. KG 9933161500
This device contains
incorporated
LED lamps.
These cannot
be exchanged
within the device.
The device is sold
with an illuminant
from energy class: