Wolf FLAMENCO D Traduction Du Mode D'emploi Original page 16

6.2 Description of grinding, milling and cleaning discs
Paper grinding discs double sided, 375 x 40mm
Grade 16, #013531, Grinding of subfloors
Grade 24, #013527, Preparing and grinding of dirty screeds
Grade 40, #013528, Grinding and levelling smoothing compounds Grade 60, #013529, Finish-
grinding of smoothing compounds Grade 80, #013530, Grinding and abrading timber surfaces
Grinding gauze double sided, 400mm
Grade 60, #013548, Grinding of parquet varnish, coatings and old surfaces Grade 80, #013331, Fine-
grinding of surfaces Grade 100, #013332, Finegrinding of surfaces Grade 120, #013333, Fine-
grinding of surfaces Grade 180, #013549, Finegrinding of surfaces,
Carbide grinding disc
Dismounting action much more aggressive compared to paper disc. High grinding efficiency. High tool life (1
0 times higher as paper grinding discs). Disc does not clog, due to open grains. Disc can be cleaned. Silicon
e or waxspray can be used additionally to reduce adhesion.
Grade 16, #013510, Abrading of anhydritescreed, removing of dirt and adhesive residues Grade 24,
#013517, For abrading and rough grinding
Cylindrical brush disc, #015735
For preparing new anhydrite and magnesiascreeds. For abrading of anhydrite-
screed, for abrading areas contaminated with paint, mortar, felt, foam and adhesive residues.
Corrugated steelbrush disc, #013539
For brushing and preparation of subfloors. For removing the loose sintered material on new anhydrite and
magnesia screed.
Flat steel brush disc #015738
For removal of foam, felt and hessian backing residues. For abrading anhydrite and selflevelling screeds, for
industrial cleaning. Brush length 45 mm. The open brushes work well with tacky residues. The brushes do n
ot clog.
Grinding disc with 6 stones K20 #013540
For grinding uneven areas of screed and levelling compounds, paint or gypsum residues. Sharp edges give
high efficiency.
Systemmillingdisc
The system milling disc can be equipped with different interchangeable milling modules. The systemdiscs
are available complete, or, as single modules Use:
System carbide milling disc, #013569: for removing thick adhesive residues and fibre, felt-
and foam residues (scraping action)
System diamond milling disc, #020943
for grinding extremely hard smoothing compounds and industrial floors, as well as epoxyand polyester coatings
grinding/polishing of parquet + cork