Wolf FLAMENCO D Traduction Du Mode D'emploi Original page 14

Security latch
1
2 Switch lever
3 Handle locking device
4 Solution dosing lever
5 Tank / cable support
6 Power cord
7 Accessory socket
Security latch
1
Lever (4) can only be actuated, if the handle is not in
2 Switch lever
vertical position. This is a safety feature! The user
3 Handle locking device
control the machine with vertical handle.
4 Solution dosing lever
5 Tank / cable support
6 Power cord
7 Accessory socket
mount the vacuum ring from the lower side of the mach
ine
connect the vacuum ring and the vacuum with the tube
Use
s
Mount discs and brushes as described in Item 5.0.

Put the handle (2) in working position with the big, right

lever (1).
We recommend to position the hand grip in the height
of the users hip.

Lift the handle slightly, to make sure the machine stan

ds horizontally.

Press the safety lock (3) at the backside of the gri
p
Switch on the machine with the respective lever (
4).
After switching on the machine, the handle will move shortly to
the right.

The direction in which the machine moves, is controlled
by lifting or lowering the grip. The more you lift or lower the grip,
the faster the machine runs to the corresponding direction.
lifting the grip: machine runs to the right
lowering the grip: machine runs to the left.
If you feel unsafe or cannot control the machine just release
lever (4). The machine will stop at once. If you have carried out
some training, you will be able to operate the machine with one
hand.
Always remove discs or brushes after work. Remove also the
cleaning tank, if one has been used. Always disconnect the
cannot
power cord after work or when leaving the machine.
Operation with vacuum cleaner
Note: the vacuum cleaner cannot on technical grounds remove
1
the grinding dust from under the discs. It will always remove the
fine dust. To clean the floor use a industrial cylinder vacuum
cleaner.
2
Operation with cleaning tank
Assemble the cleaning tank with 2 supports to the handle.
1.
2. Check the
3
set
3. Put the tank a on the lower supp Block A
ort
by pushing down the upper support
4.
Insert C as shown in the pict
5. 1. Insert B in the hole on the handle
ure
2. Insert the ring in the lever
6.
7. Screw the catch on the push
4
rod
Check that the chain B is not under tens
ion
1
5
6