Important Safeguards - Pool Blaster LEAF DEMON Manuel De L'opérateur

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

For Bottom Cleaning

Press the ON/OFF button on the battery box to start the Leaf

Demon. Using the pool pole, lift the Leaf Demon into the pool

and guide it to the pool bottom in the "Wheels Down" position.

For Surface Cleaning

Push the pole adapter down

until the adapter locks in place.

Turn the cleaner "ON."

The Leaf Demon may now be

used in the "Wheels Up" posi-

tion to skim leaves and other

floating debris from the pool's

surface.

Adjusting the Clearance Height

The Leaf Demon is packaged

with its clearance height in the

"LOW" position.

The height of the Leaf Demon

can be raised up to 1/4 inch if

needed by doing the following:

1. Use a small scewdriver or

pair of needle-nose pliers to

remove the "E"-clip from the

top of the wheel pivot shaft.

2. Remove the wheel pivot

shaft assembly. Don't lose the

"E" - clip and spacer.

(see Photo).

3. Place the spacer on the

pivot shaft and guide the

shaft back into the body from

beneath.

4. Replace the "E"-clip on the

top of the shaft.

Repeat these procedures on

the remaining 2 wheel pivot

assemblies.

USING THE POOL BLASTER LEAF DEMON

Maintenance

ALWAYS clean out the debris bag following each use and

carefully remove any debris that might be stuck in the propel-

ler area of the cleaner.

Remove the batteries from the battery box prior to long-term

storage (ie. at the end of the pool season).