Air Supply And Connections - Haussmann PNT122-B Manuel De L'utilisateur

ADDITIONAL SAFETY INSTRUCTIONS FOR AIR-POWERED DUAL-ACTION SANDER
GENERAL SAFETY INSTRUCTIONS
SERVICE
Tool service must be performed only by qualified repair personnel.

When servicing a tool, use only identical replacement parts. Use only authorized

parts.
Use only the lubricants supplied with the tool and specified by the manufacturer.


AIR SUPPLY AND CONNECTIONS

The air supply connection must not hold pressure when air supply is disconnected.

If an incorrect fitting is used, the tool can remain charged with air after
disconnecting and thus will be able to work even after the air line is disconnected,
possibly causing injury.
Do not use any type of reactive gases, including, but not limited to, oxygen and

combustible gases, as a power source. Use filtered, lubricated, regulated
compressed air only. Use of a reactive gas instead of compressed air may cause
the tool to explode which will cause death or serious personal injury.
Use only a pressure-regulated compressed air source to limit the air pressure

supplied to the tool. The regulated pressure must not exceed 100 PSI. If the
regulator fails, the pressure delivered to the tool must not exceed 150 PSI. The
tool could explode which will cause death or serious personal injury.
Always disconnect air supply from tool:

a) before making adjustments.
b) when servicing the tool.
c) when clearing a jam.
d) when tool is not in use.
e) when moving to a different work area, as accidental actuation may occur,
causing injury.
1. Always inspect air tool prior to each use to:
a) ensure proper use of air source;
b) determine whether tool is in proper working order.
2. An improperly functioning tool must not be used.
3. Never use oxygen, or any other combustible or bottled gas to power this tool.
4. Never use in presence of flammable liquids or gases.
5. Only use parts which are specifically designed for use with this tool.
6. Drain the air tank daily. Water in the air line will damage the air-powered
dual-action sander.
7. Clean air inlet filter weekly.
8. Line pressure should be increased to compensate for unusually long air hoses
(over 26 ft/8 metres). The hose diameter should be 3/8"(10 mm) I.D.
9. Keep hose away from heat, oil and sharp edges. Check hose for wear, and make
certain that all connections are secure.
10. Keep air-powered tools clean and lubricated. Daily lubrication is essential in order
to avoid internal corrosion and possible failure.
11. Do not overload the tool. For maximum efficiency, allow the tool to operate at its
optimum speed.
12. Do not increase the air pressure above the manufacturer's recommended level.
Doing so will cause excessive wear on moving parts, and possible failure.
13. In the interests of safety and in order to avoid possible damage to the tool and
injury to the operator, make sure that the tool has come to a complete stop before
putting it down after use.
14. Verify that the workpiece is secure in order to free both hands to control the
air-powered dual-action sander.
15