Selecting The Place Of Installation - IARP B-ICE N Instructions D'emploi Et D'entretien

MOVEMENT
The unit is shipped anchored on wooden pallets and compeletely wrapped with angular plates,
carton cover and nylon.
The refrigerator must be moved only using a service-lift.
It is forbidden to pile up more than 2 units.
The equipment should not be absolutely "parked"
in horizontal position or overturned.
The cabinet is equipped with pivoting wheels
for the movement in the compartment.
Do not try to overcome steps or steep ramps: such
operation may damage the wheels.
Place the cabinet on a perfectly even surface,
mounting and adjusting the feet for perfect
levelling.

SELECTING THE PLACE OF INSTALLATION

In selecting the place of installation, ensure that the following instructions are observed, this being
vital for proper and troublefree working of the cabinet:
• Do not install the cabinet outdoors.
• Do not install the cabinet in the vicinity of heating radiators or other heat sources.
• Do not install the cabint where it is exposed to direct sun light (e.g. through windows).
• Do not install the cabinet where it is exposed to drafts from ventilators open doors.
• Pay attention to air outlet from air conditioners/ ventilators.
• Keep the air intake and outlet area around the plinth area of the cabinet clear of cartons and other
obstacles.
• It is necessary taht the condensing unit obtains a good circulation of air around it; also the area
around the condensing unit should not be obstructed by boxes or other objects; keep a distance
from the wall of 10 cm. at least.
Air-Condition
-15-