Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6.1. Heating
OFF = heating off (led: ON)
ON = heating on (led: ON + LOW)
LOW = lower temperature (led: ON + LOW)
HIGH = higher temperature (led: ON + HIGH)
2H = heating is on for 2 hours (LOW or HIGH), then
turn off automatically.
When activated, the led blinks till the end of the
second hour.
You can stop heating in any time pressing OFF but-
ton.
Usually, heating stops automatically (LOW or HIGH
temperature) after 1 hour from switch on.
ATTENTION! It is absolutely necessary TURN OFF THE HEATING (OFF) WHEN THE TABLE
IS NOT USED AND AT THE END OF EACH WORKING DAY.
The heating works with the pressure of the body, so we do not feel any sensation of heat if it is not stressed
by the weight of a body. It is recommended to always leave a weight laid (for example towels or magazines)
to maintain the minimum temperature.
6.2. Remote hand control
On request, the table can be adjusted by a remote hand control already connected and that can be placed
on the side by a magnet.
6.3. Wireless pedal (without cable)
If the table was equipped with a wireless pedal, follow the instruction in § 7.3. Controls for the installation
and proper use.
The wireless pedal works with two AAA batteries: unscrew the two screws on
the plate that is on the top of the pedal to replace the batteries.
6. OPTION ON DEMAND
9
Publicité
Table des Matières
