PCM SR10J-GSC-E11AZ Mode D'emploi page 2

English
IMPORTANT: To use this tool, the machine must be modified and rebuilt. P.C.M. Willen SA disclaims
all responsibility!
1) Remove the protection sheet that cover
the existing tool.
2) Remove the belts and the motor of the
tool.
3) Remove the original tool by 4 screws.
4) Remove the back tool post for the back-
spindle tools.
5) Remove the spindles on the back tool
post.
6) Milling of the bridge to a thickness of 49
mm. Warning! If you milling more, the
back tool post will be broken. (See picture)
7) Add the back tool post to the machine.
8) Align the back tool post with the machine.
9) Add the tool SR10J-GSC-E11AZ to the
machine and fix them with the 4 screws.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
SR10J-GSC-E11AZ
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
BT
Validation: 13.03.17
10) Align the tool SR10J-GSC-E11AZ
11) Add the motor to the tool and tighten the
belts.
12) Add the belt cover to the tool.
13) Try the tool before adding the protection
sheets to the machine.
14) Set up the offset of all the tools and limit
the end position of the axes.
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
Document:
SR10J-GSC-E11AZ
1- Mode
d'emploi.docx
Page: 2 de 4
4 screws
office@pcm.ch