BH FITNESS G858 Instructions De Montage Et Utilisation page 23

10.- COVER PLACEMENT.-
Place the bracket cover (131) and fix it
with the screws (62) and (14), Fig.14.
Place the bar covers (19), (26), (119),
(120) and secure them using the
screws (27) and (14), Fig.15.
11.- FITTING THE PEDALS.-
Place the left pedal (115) on the left
footrest. Secure it using the screws
(14) and washers (139), Fig.16.
Go through the same procedure for the
right pedal (64), Fig.16.
Fit the covers (63), Fig.17.
LEVELLING.-
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This can
be achieved by screwing the adjustable
feet (83) up or down, as shown in
Fig.18.
If excessive noise occurs during use,
apply oil (143) to the rail, Fig.18.
MOVEMENT & STORAGE.-
The unit is equipped with wheels which
make it easier to move. The two
wheels at the front of the unit make it
easier to place the unit in to any
chosen position by lifting the rear
slightly
Store your unit in a dry place,
preferably not subject to changes in
temperature.
MAINS CONNECTION.-
Insert the jack (m) for the transformer
into the connection hole on the main
body (k) (bottom, rear of the machine)
and then plug the transformer (138)
into a 230 V mains supply, Fig.19.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE.
23