Setting The Antenna Unit - Pioneer GEX-6100TV Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Note:
• Before finally installing the unit, connect the
wiring temporarily, making sure it is all connect-
ed up properly, and the unit and the system work
properly.
• Use only the parts included with the unit to ensure
proper installation. The use of unauthorized parts
can cause malfunctions.
• Consult with your nearest dealer if installation
requires the drilling of holes or other modifica-
tions of the vehicle.
• Install the unit where it does not get in the dri-
ver's way and cannot injure the passenger if there
is a sudden stop, like an emergency stop.
• When mounting this unit, make sure none of the
leads are trapped between this unit and the sur-
rounding metalwork or fittings.
• Do not mount this unit near the heater outlet,
where it would be affected by heat, or near the
doors, where rainwater might splash onto it.
(Never install in locations such as the above
because of the danger of malfunction due to high
temperatures.)
• Before drilling any mounting holes always check
behind where you want to drill the holes. Do not
drill into the gas line, brake line, electrical wiring
or other important parts.
• If this unit is installed in the passenger compart-
ment, anchor it securely so it does not break free
while the car is moving, and cause injury or an
accident.
• If this unit is installed under a front seat, make
sure it does not obstruct seat movement. Route all
leads and cords carefully around the sliding mech-
anism so they do not get caught or pinched in the
mechanism and cause a short circuit.

Setting the Antenna unit

Note:
• Mount the antenna on the inside of the car on
fixed windows such as rear windows or hatchback
windows.
• To assure optimum reception, it is recommended
you mount the TV antenna on a rear (hatchback)
windows pointing down as shown in the Fig. 1,
Fig. 2 and Fig. 3.
• Mounting the antenna near a radio antenna (par-
ticularly a booster type) will result in noise. In
this case, consult your dealer concerning mount-
ing location.
• If the antenna is mounted near a radio antenna,
reception quality may be effected during simulta-
neous reception of TV and radio broadcasts.
• You may not be able to mount the antenna on
windows of certain size, Be sure to select a win-
dow that is large enough.
• Before mounting the antenna, check the location of
the unit you are going to connect the antenna to, and
make sure it is near enough for the antenna cable to
reach (Antenna cable length: 6 m [236 in.]).
• If you use this product in areas where the broad-
cast signal is weak, the included antenna's sensi-
tivity may fall, resulting in a poor picture.
• Never install on top of a glass antenna or heating
wires.
• Secure the antenna firmly, and do not use if it
comes loose. If the antenna falls down, the tips of
the elements may cause injury.
• After installing, make sure children don't play
with it as it may result in unexpected injury.
14

Publicité

Table des Matières
loading

Table des Matières