Battery Operation - REV 0514901555 Mode D'emploi

Protection type: Receiver IP20 – only suitable for use indoors
Transmitter - suitable for sheltered outdoor use
Transmission radiation takes place within the milliwatt range
for just a few milliseconds when the transmitter is activated
and is not dangerous to health.
REV Ritter GmbH hereby declares that the model 14901 and
04444R2 is in accordance with the underlying requirements and
other relevant provisions of Directive 1999/EC. For the complete
CE Declaration of Conformity please refer to www.rev.biz under the
article in question.

3. Battery operation

Remove the cover from the battery compartments
the specified batteries – pay attention to correct polarity (+/-).
Safety instructions for batteries
• I nserting the batteries the wrong way round (incorrect +/-
polarity) can damage/destroy the appliance
• D o not store batteries within the reach of children. This applies in
particular to batteries that could be swallowed
• S eek immediate medical help for affected person in the event of a
battery being swallowed
• D o not attempt to revive batteries by heating up or similar mea-
sures. Primary batteries may not be recharged as this can result in
electrolyte leakage, fire and explosions
14
+ and insert
➀ ➁
• D o not immerse batteries in water and do not store in a damp
place. Always store in a dry and cool place
• D o not throw batteries into fire. Do not attempt to open, solder
or weld
• D o not short-circuit batteries
Please dispose of batteries in compliance with legal requirements
(see section no. 15)
4. Operation by power supply unit
Insert the plug of a suitable power supply unit in the socket
make sure that the polarity of the plug and the output of the power
supply unit are correct (4.5V DC). We recommend removing the bat-
teries from the receiver if operating by power supply unit.
5. Coding
The transmitter  and receiver  must be assigned the same code
first before you can operate the receiver  by remote control. 16
different coding possibilities are available to ensure that the receiver
reacts without fail to the transmitter's signals. Open the cover of the
battery compartment on the transmitter
a position between 1 and 16 chosen by you. The switch
receiver A has to be set the same position.
TIP: T est the required function before final installation at your chosen
installation point (see text no. 11).
–
➄
and turn the switch to
➁ ➂
on the
➂
15