TROUBLESHOOTING
For any enquiries on spare parts please contact your authorized dealer. If any
malfunction of the air conditioner unit is noted, immediately switch off the power
supply to the unit. Check the following fault conditions and causes for some
simple troubleshooting tips.
1. The compressor does not operate 3 minutes
after the air conditioner unit is started.
2. The air conditioner unit does not operate.
3. The air flow is too low.
4. Discharge air flow has bad odor.
5. Condensation on the front air grille of the
indoor unit.
6. Water flowing out from the air conditioner
unit.
If the fault persists, please call your local dealer / serviceman.
Fault
Causes / Action
– Protection against frequent starting. Wait for
3 to 4 minutes for the compressor to start
operating.
– Power failure, or the fuse needs to be
replaced.
– The power plug is disconnected.
– It is possible that your delay timer has been
set incorrectly.
– If the fault persists after all these
verifications, please contact the air
conditioner unit installer.
– The air filter is dirty.
– The doors or windows are open.
– The air suction and discharge are clogged.
– The regulated temperature is not high
enough.
– Odors may be caused by cigarettes, smoke
particles, perfume etc. which might have
adhered onto the coil.
– This is caused by air humidity after an
extended long period of operation.
– The set temperature is too low, increase the
temperature setting and operate the unit at
high fan speed.
– Switch off unit and call dealer.
1-24