Publicité
Les langues disponibles
Les langues disponibles
MANUAL FOR OPERATION INSTRUCTIONS FOR SWIMMING POOL
LED PROJECTORS 12V ~
-Manufactured in ABS - optical medium that can be easily dismantled
Qualified people are needed to install this projector.
To only be used in the event of water immersion.
IMPORTANT: this manual contains information of prime importance regarding safety measures to adopt when installing and commissioning. It is consequently essential that the installer and the user
read these instructions carefully before starting to assemble and start up.
IMPORTANT SAFETY NOTICE: Electrical installations for swimming pools must comply with requirements of standard NF C 15-100 and regulations in force (domestic power grid).
NOTE : If the SPOTLIGHT bulb's power is supplied by an electronic transformer there is a risk it may not work (contact your retailer for details).
Works only with a safety transformer (toroidal transformer) Class III 230V / 12V ~.
Provide a power supply 10% higher than the power absorbed by the spotlight.
For example: A power supply of 200 watts provides power for 5 spotlights (12 LED white) :
See the table below to identify the section of cable depending on the length and power. For low currents and short son, please be very superfluous. Remember that falls can be very high on bad connections, lugs and son Loose
oxidized.
Measure the voltage at the end of the cable without the projector (minimum required voltage: 10.5 V / maximum voltage supported: 13.5 V).
6 white LED
2 x 2,5 mm²
2 x 4 mm²
For a loss of 0.5 V
2 x 6 mm²
2 x 10 mm²
Insert the cable in the grommet at the recess's bottom and leave a sufficient length to be able to pose the spotlight on the pool edge, since the grommet is tightened, the only thing to do now is to insert the spotlight in its
recess.
If the external flexible cable or cord of this luminaire is damaged, it must only be replaced by the manufacturer, its service agent or similarly qualified person, in order to avoid all risks.
Color LEDs for headlamps
- 10 colours / 5 sequences of linked colours.
- Change of colours or sequences (standard) by disconnection on the power switch "START/STOP".
- Change of colours or sequences by the intermediary of the KIT (optional) Receiver-Controller-Modulator with wireless remote control.
- Keep the pre-defined colour or sequence after the bulb is turned off.
Instructions for use:
When the power is turned on, the bulb lights up. To change the colour or sequence, press START / STOP on the power switch in manual mode. The change procedure requires the switch to be pressed for less than 1 second.
The first time it is pressed, the bulb initialises on the first fixed colour. Each subsequent time it is pressed, the fixed colours are displayed until the tenth, and then the five linked sequences are shown until the first fixed colour
returns. Pressing for more than 10 seconds leads to memorisation of the current colour or sequence, making it possible to restore the lighting with the pre-defined colour or sequence.
12 white LED
13 m
2 x 2,5 mm²
21 m
2 x 4 mm²
For a loss of 0.5 V
31 m
2 x 6 mm²
52 m
2 x 10 mm²
4 x 36 = 144W.
12 LED colors
8 m
2 x 2,5 mm²
12 m
2 x 4 mm²
For a loss of 0.5 V
19 m
2 x 6 mm²
32 m
2 x 10 mm²
9 m
13 m
20 m
32 m
GB
Publicité
