Bresser SH 4000 Notice D'utilisation page 19

Step Operation
3 Drill mounting
holes
4 Mount rear
panel
5 Affix the
house number
6 Install battery
7 Connect solar
cell to circuit
board
8 Fit the house
number light
On completing the installation, remove the protective foil from the solar cell
Period of illumination:
Dull days: up to 5 hours
Sunny days: over 9 hours
User's Handbook
0415880 Solar_Hausnr_SH 4000-Dru19 19 0415880 Solar_Hausnr_SH 4000-Dru19 19
Solar Powered SH 4000
Description
DANGER: When drilling and installing screws, take care to
avoid damaging electricity cables and gas and water pipes. This
could lead to severe injuries and damage.
NOTE: The fastening materials included in the pack are
suitable for direct mounting to brick or concrete walls. If the
substrate is other than these, suitable fastening materials must be
obtained from an appropriate retail outlet.
Drill two mounting holes (6 mm diameter) in the substrate and insert
the plugs included in the pack.
Secure the rear panel to the substrate with the screws supplied.
TIP: Use a spirit level to adjust the rear panel so that it is level.
See Section 7.2
See Section 7.3
Plug the connecting lead into the socket in the printed circuit board.
With a small Phillips-type screwdriver, install the screws [11] on the
underside of the house number light.
19
Brennenstuhl
3
6
Version: S-P_11_2006
22.02.2007 15:41:32 22.02.2007 15:41:32