Installation And Operation; Installation - Bresser SH 4000 Notice D'utilisation

7

Installation and operation

The basic functions of the house number light are explained in this section. Read it through carefully
so that you will understand and be able to make use of all the functions.
IMPORTANT: Observe the following instructions, especially those relating to safety, in order
to prevent operating errors and potential defects.
If you have any problems, refer to the List of faults (Section 11) or contact our Service Centre (for
contact details, see Section 12)
7.1

Installation

NOTE: It is advisable to install the light in a position where it is exposed to direct sunlight. The
duration of illumination depends on the intensity of the sunlight.
Step Operation
1 Open up the
house number
light
2 Mark out
mounting
holes
User's Handbook
0415880 Solar_Hausnr_SH 4000-Dru18 18 0415880 Solar_Hausnr_SH 4000-Dru18 18
Solar Powered SH 4000
Description
Unscrew and remove the screws (11) from the underside of the
light using a small Phillips-type screwdriver.
No. Designation Function
11 Screws Fasten the cover to the rear panel
Using the rear panel as a template, mark out the mounting holes
with a pencil.
TIP: Use a spirit level when marking out the mounting holes.
This will subsequently ensure that the light is mounted horizontally.
18
Brennenstuhl
11
5
Version: S-P_11_2006
22.02.2007 15:41:31 22.02.2007 15:41:31