Cleaning And Maintenance - STARFRIT 024005 Instructions Pour L'usage Et L'entretien

3. Press the ON/OFF switch located on the right side of the appliance to start.
4. Press steam button ''
should be in the pushed position; set manually to the '' '' position. Wait until
the steam light indicator is illuminated. The steam function is now ready to use.
NOTE: During continuous operations, the coffee indicator light will likely turn off
due to the inadequate temperature of the water in the boiler, but it does not mean
the unit will stop operating, you may continue to make cappuccino regardless.
5. Add 2 to 3 oz (59ml to 89ml) of cold milk to a container. For best results, we
recommend that you use a narrow, short container to fit under the steam
wand. For optimal results, the milk and its container should be very cold.
NOTE: In choosing the size of jug, it is recommend the diameter is not less than
70±5mm ( 2,75 in ± ¼ in), and bear in mind that the milk may double in volume,
ensure that the height of container is high enough. For best results use fresh cold
milk (light milk will froth easier).
6. As soon as the steam light turns on, plunge the steam/froth wand into the milk
without touching the bottom of the container, then turn the selector dial to the
" " position. Steam will come out from the steam wand. Froth milk by moving the
container of milk up and down.
7. Once you have frothed the milk, turn the selector dial to the '' '' position. The
power light will turn off.
NOTE: Clean steam outlet with wet sponge immediately after steam stops
generating but be careful not to burn yourself!
8. Pour the frothed milk into the previously prepared espresso, now the cappuccino
is ready.
NOTE: Sweeten to taste and if desired, sprinkle the froth with a little cocoa powder.
9. Press the ON/OFF switch to the off position.
NOTE: If you want to make coffee again after frothing milk.
10. Press the steam button to the release position which is the "
11. Press the ON/OFF switch located on the right side of the appliance to start.
12. Wait until the coffee indicator light turns off then turn the selector dial to the "
position. The power light will illuminate.
13. In order to stop the water flow once the cup(s) is/are full, turn the selector dial
manually to the '' '' position. The power light will turn off.
14. Remove the detachable water tank, empty, rinse and dry carefully then place back
in the appliance.
15. Unplug the power cord from the electrical outlet.
WARNING: To avoid splattering of milk, do not lift the steam/froth wand above
the surface of the milk while frothing. Ensure the selector dial is in the '' '' position
before removing the jug.

CLEANING AND MAINTENANCE

THE APPLIANCE
• Unplug the power cord from the power outlet each time you clean it and allow to
cool.
8
''located in the front of the espresso machine. The button
" position.
"