STARFRIT 024005 Instructions Pour L'usage Et L'entretien page 6

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

7.
Turn the selector dial to the "
NOTE: During continuous operations, the coffee indicator light will likely turn off
due to the inadequate temperature of the water in the boiler, but it does not mean
the unit will stop operating, you may continue to make coffee regardless.
8.
After a few moments, the water will flow through.
9.
In order to stop the water flow once the cup(s) is/are full, turn the selector dial
manually to the '' '' position. The power light will turn off.
WARNING: Do not leave the coffee espresso maker unattended while making
coffee as you may need to operate manually at times!
10. Remove the cup(s).
11. Press the ON/OFF switch to off position.
12. Unlock the filter holder handle by turning clockwise. Remove the filter holder
handle from the appliance.
NOTE: Do not touch the ground coffee filter when it is hot.
13. Allow the appliance to cool for 5 to 10 minutes.
14. Wash the ground coffee filter and dual spout portafilter under running water to
remove any remaining residues.
15. Remove the detachable water tank, empty, rinse carefully, dry and place back in the
appliance.
16. Unplug the power cord from the electrical outlet.
HOW TO MAKE ESPRESSO COFFEE
To make a cup of good hot espresso coffee, it is recommended to preheat the
appliance beforehand (including the ground coffee filter and dual spout portafilter to
ensure that the flavour of the coffee is not altered by the cold parts. Preheat your cup,
rinse with hot water from the hot water outlet and place on the cup warming tray.
STEPS
1.
Take the detachable water tank and fill the water tank with drinking water. The
water level should not exceed the "Max" level (1,2L or 40 oz) or as indicated in
the detachable water tank. Replace the detachable water tank in the back of the
appliance. Close the water tank cover lid.
NOTE: Check water level before use and replace the water daily. Do not use
mineral or distilled water.
2.
Remove the filter holder handle by turning the handle clockwise.
3.
Using the measuring scoop, add coffee grounds into the ground coffee filter
(1 scoop = 1cup, 2 scoops = 2 cups).
NOTE: The perfect espresso ground coffee feels like fine sand. When rubbed
between your fingertips, it will lightly stain them while keeping its granular
consistency.
4.
Remove excess coffee grounds from the rim of the ground coffee filter, then press
the coffee ground lightly with the flat end on the measuring scoop (tamper).
5.
Set ground coffee filter into dual spout portafilter. Ensure the opening of the ground
coffee filter is aligned with the groove in the dual spout portafilter, then insert the
filter holder handle into the appliance in the UNLOCK '' ''position. Turn firmly
counter clockwise until it is fully secure in the LOCK '' '' position.
6
" position. The power light will illuminate.

Publicité

Table des Matières
loading

Table des Matières